Page 1 of 1
New SKS-M stock
Posted: Wed Oct 31, 2012 10:29 pm
by jkysmrf
So after months of patiently waiting, my bullpup stock came in. Only minor fitting required, plus had to cut a slot in the stock to allow for the front sling mount to fit. It feels really solid and can't wait to try it out. Don't get me wrong - the M was fine before and is fully intact inside, but just wanted something more "fun". OAL is about 26 3/8"
Before
After
Posted: Thu Nov 01, 2012 6:00 am
by SR9
Looks good. Are there any issues with 922 compliance with these mods?
Posted: Thu Nov 01, 2012 6:38 am
by jkysmrf
But of course. Had to go with stock, take off upper handguard, US made trigger, hammer, sear. Stupid $90 extra, but oh well - this is an expensive hobby.
Posted: Thu Nov 01, 2012 6:56 am
by jkysmrf
Now I think that it's just screaming for a can
Posted: Thu Nov 01, 2012 8:16 am
by PaiN
jkysmrf wrote:Now I think that it's just screaming for a can
Now you hit the nail on the head....
Posted: Thu Nov 01, 2012 11:55 am
by SR9
jkysmrf wrote:But of course. Had to go with stock, take off upper handguard, US made trigger, hammer, sear. Stupid $90 extra, but oh well - this is an expensive hobby.
Ok, that is what I thought. Have not done anything like that...yet.
Posted: Thu Nov 01, 2012 11:58 am
by jkysmrf
My PTR compliance parts for the G3 kit I had done were much more expensive. This wasn't too bad.
Posted: Thu Nov 01, 2012 12:58 pm
by BigJonBoy
That is awesome!